Auralex SonoFlat System SFS-112 Manuel d'utilisateur télécharger pdf (Page 3)

SonoFlat Panel Installation Guide

➋

Apply Tubetak Pro to the back of the SonoFlat

Panel, as pictured.

➌

Carefully press SonoFlat Panel to the marked

location of the wall or ceiling. Maintain continuous

pressure. Depending on environmental and

surface conditions, it will take anywhere from

2-4 minutes to hold.

➊

Mark intended location of each SonoFlat

Panel on the wall or ceiling.

SonoColumn Installation Guide Continued

➍

Place SonoCollar around SonoColumn, if

desired. The inside section of each SonoCollar

can also be used to increase the height of the

SonoColumn by 6”.

➌

Carefully press SonoColumn to the marked

location of the wall or ceiling. Maintain continuous

pressure. Depending on environmental and

surface conditions, it will take anywhere from

2-4 minutes to hold.

TIP

For a stronger hold, with the adhesive applied, press

SonoColumn firmly into place, immediately remove it and

press it firmly again into the same spot.

TIP

You can use T-Pins to temporarily hold the panel in place

while the adhesive sets.

1 2 3 4

Pas de commentaire

Auralex SonoFlat System SFS-112 Manuel d'utilisateur Page 3